Resetting the device's WiFi
Safe mode — enable the AP
To reach the device if the AP is turned off and it is not connected to your network: start safe mode by unplugging and plugging in the RF-Hub 5 times in a row. Unplug the power when the light is orange and before it turns green, with roughly one second between each cycle.
On the fifth plug-in, the device flashes blue, indicating that safe mode is active and the AP is visible. You can then connect to the device's AP and open http://192.168.200.1 in a browser to enable the AP or configure WiFi settings.
Configure via the USB port
WiFi settings can also be changed by connecting the device to a computer's USB port using a compatible browser such as Chrome or Microsoft Edge.
- Connect the device to the computer's USB port
- Open
https://qtrl.me/rfhub/flashin your browser - Click the Connect button
- Select the device called "USB JTAG/serial debug unit"
- Use the menu to change WiFi settings
Factory reset
Via the browser
Access the device through the browser using either its IP address on the network or http://192.168.200.1 if you are connected to its AP, and then perform a factory reset through the interface.
Safe mode
Unplug and plug the device into a USB port 10 times to perform a factory reset. Unplug the power before the light turns green. On the tenth plug-in, the device will factory reset and restart.